Laboratory Frame Connectors

The low-profile contour of these laboratory connector delivers simplicity and strength. The angled adjustment screws allow easy set-up and prevent misalignment. The smooth, rounded surfaces are easy to clean and their small size maximizes lab-frame space. Each has a bright, dipped aluminum finish sealed with silicon for maximum protection against corrosion. Grip size is 0 to 17 mm (0 to 0.66"). Available singly or in more economical packages of 12.

You can use these with our 1/2" (item # 22200) or 13 mm (item # 22205)  aluminum, stainless steel, or fiberglass rods as well as our lattice frame feet (item # 22010) to create your own custom rack/lattice/frame systems as shown here.

For a more economical alternative, consider our Economy Laboratory Frame Connectors, item # 22039.

WARNING: OHAUS products can expose you to chemicals including the chemicals listed in this Table, which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. These and other Proposition 65 chemicals may be present only in residual amounts, or contained internally in OHAUS equipment, or encapsulated in another material where exposure is unlikely or negligible. This warning is being provided out of an abundance of caution.